Wisycom BFLT1-B-SC RF Over Fiber Tx
Wisycom BFLT1 Module
Wisycom BFLT1 — Single RF-over-Fiber module with selectable filters and Bluetooth long range. Equipped with an optical laser which trasform an RF signal to an optical signal.
The module BFLT1 can work in:
IFB mode: to send low power IFB/IEM signal over fiber to a remote area
ANT mode: to receive signal from an antenna placed on a remote area
BFLT1 FEATURES:
Monitor & control through Bluetooth to adjust parameters in real time (Wisycom BT App)
Wide RF band: 170-1260 MHz
Operating voltage range: 9 ÷ 18 Vdc
2 RGB LEDs for RF overload and system status indication
Easy configuration through a high contrast OLED white display and 4 key navigation buttons
Antenna booster 12V, 150mA max
4mW (6dBm) optical laser to cover miles away
20 band pass filters and tunable filter 1MHz step software selectable to increase RF robustness
compatible with expansion board EXP3 and EXP2
| undefined | |
|---|---|
| FREQ RANGES | 170-1260MHz |
| RF CONNECTOR | BNC-F or N-F |
| ANTENNA BOOSTER | +12Vdc, 150 mA max |
| TUNABLE FILTER | 470-758MHz (UHF), 40MHz of BW |
| FIXTED FILTER | 820-832MHz, 733-758MHz, 940-960MHz |
| RF TO FIBER LINK WORKING MODES | ANT (for reception link), IFB (for transmission link) |
| OPTICAL CONNECTOR | SC/APC or ST/APC or LC/APC |
| OPTICAL POWER | 6dBm [4mW] |
| WAVELENGTH | 1550 nm |
| MANAGING INTERFACE | Display menu and 4 buttons, Bluetooth 5 {Wisycom BT App) |
| LEDs | 2 multicolor RGB LEDs to east indicates BFLx1 status, LED1 status: red:RF overload, blue:booster enabled, green:RF, LED2 status: red:alarms, blue: Bluetooth enable, green:no alarm, no Bluetooth |
| POWER SUPPLY | 9-18Vdc |
| POWER CONNECTOR | Hirose 4pin (pin1:GND, pin4:Vdc) |
| POWER CONSUMPTION | 2 W (DC antenna booster OFF), 3,5 W (DC antenna booster ON) |
| DISPLAY | High contrast OLED white display (128 x 64 pixels) |
| MOUNTING | 4 holes (M4 screw type) |
| TEMPERATURE RANGE | -10-+55 °C |
| DIMENSIONS | 70.2mm(L) x 127.1mm(H) x 26.1mm(D) |
